RIB K5 cK Manual De Operación Y Seguridad página 26

Pag. 26 di 44
E
N
G
PLATE TO BE CEMENTED
L
I
S
H
NYLON RACK MODULE 4
with zinc plated angle Iron, In 1mt. bars.
Ideal for gates up to 1,000Kg / 2,200lbs weight
1mt / 3,28"
10mt / 32,8" (1mt/3,28" x 10)
RADIO TRANSMITTER MOON
ACG6082
In order to make the systems mentioned above give the best performances, you need to
install an antenna tuned on the frequency of the radio receiver installed.
N.B. Pay attention not to let the central wire of the cable to came Into contact with
the external copper sheath, since this would prevent the antenna from working.
Install the antenna vertically and in such a way the remote control can reach it.
SPARK ANTENNA 433
SPARK BLINKER with in-built intermittent card
MECHANICAL STRIP
L=2MT - 6,56 FEET
With double-safety contact, you can cut the length you need.
code ACG8101
code ACS9000
code ACS9001
ACG6081
SPARK ANTENNA
code ACG5252
code ACG7059
code ACG3010
ACCESSORIES
FIT SYNCRO PHOTOCELLS FOR THE WALL-INSTALLATION - code ACG8026
The range you can set Is 10÷20mt 49÷100"
You can fit many couples close together thanks to the synchronising circuit.
Add the SYNCRO TRANSMITTER, code ACG8028, for more than 2 photocells couples
(up to 4).
COUPLE OF BUILT-IN BOXES FOR THE FIT SYNCRO
BLOCK KEY SELECTOR FOR WALL-INSTALLATION
BLOCK KEY SELECTOR TO BUILD-IN
The probe detects the motor temperature to operate the heating system under low
temperature conditions (connect to connector J8)
PROBE
FIT SYNCRO
code ACG8051
BLOCK
code ACG1053
code ACG1048
PUSH-BUTTON FLAT
cod. ACG2013
PROBE
cod. ACG4665