Progress PBN 1220 Manual De Instrucciones página 12

12 progress
Fitting the shelf support rails
To install, first reattach the rails at the back,
then put them into position at the front and
press them into place.To clean the shelf sup-
port rails, soak in warm soapy water and re-
move stubborn marks with a well wetted
soap impregnated pad. Rinse well and dry
with a soft cloth.
Replacing the oven light
Important! Separate the appliance from
the power supply by switching off the
fuse.
If the oven bulb needs replacing, the new
bulb must have the following specifications:
– Electric power: 15W / 25W
– Electrical rating: 230 V (50 Hz)
– Heat resistance up to 300 °C
– Connection type: E14
These replacement bulbs can be purchased
from your dealer.
To change the oven light:
1. Before proceeding ensure the oven is
cool and is disconnected from the elec-
tricity supply.
2. Push in and turn the glass cover anti-
clockwise
3. Remove the faulty bulb and replace with
the new one.
4. Refit the glass cover and restore the elec-
trical supply.
The oven door
The oven door consists of two panes of
glass. The oven door can be disassembled
and the internal panes can be removed to
make cleaning easier.
Warning! Remove the oven door before
cleaning it. The oven door could abruptly
close if you try to remove the internal
panes of glass when the door is still
assembled.
To do so, proceed as follows:
1. Open the door fully.
2. Locate the two door hinges