What To Do If - Progress PBN 1220 Manual De Instrucciones

14 progress
9. Carefully lift the top pane out a little and
pull out the pane which is visible on all
four sides of the frame.
1
Clean the oven door with lukewarm water
and a soft cloth. Do not use any scourers,
metal wool, abrasive sponges or acids which
could damage the heat reflecting special sur-
faces of the inner pane.
After cleaning the inner pane put back in the
door. Insert the door in the oven; proceed in
reverse order. Be mindful of the correct align-
ment of the panes.
To perform this operation correctly, proceed
as follows:
1. The inner pane with the frame on four
sides must be installed so that the screen
faces the outside of the oven. Touch the
visible surface. If there is no roughness on
the level of the screen, the pane is inser-
ted correctly.

What to do if...

If the appliance is not working correctly,
please check the following before contacting
the Electrolux Service Centre.
2. The inner pane must be put in its place
90°
After putting the panes in the oven door, se-
cure them in reverse order, following the
guidelines in Point 8 .
Important! Never clean the oven door
when it is warm as the panels might
shatter. If you can see scratches or
cracks in the glass panel, call your
2
nearest service centre immediately to
have the panel replaced.
Models in stainless steel or aluminium:
Clean the oven door and operating panel in
stainless steel or aluminium with a damp
sponge and then dry carefully with a soft
cloth. Never use metal pads, metal wool,
acids or abrasives for cleaning because they
may scratch the surfaces.
Cleaning the oven door seals
A seal is fitted around the opening of the
oven.
Important! Check the condition of the
seal on a regular basis.
If you notice damage to the seal, please
contact the nearest service centre im-
mediately. Do not use the oven until the
seal has been replaced.
according to figure.