Operating Mode "Networked; Setting The Maximum Charging Current; Advanced Settings - Mennekes AMTRON Serie Manual De Instrucciones

6.2.4 Operating mode "Networked"

Several devices are connected via ethernet. This enables use of local load management and a connection to the
Backend-System can be established for all networked devices (via gateway).
Requirements:
9
The accessory kit for local networking of multiple devices is installed.
9
Multiple devices are networked.

Installation manual of the accessory kit.

6.2.5 Setting the maximum charging current

f Navigate to the "Settings" menu and set the following parameters:
„ "Operator Current Limit (A)"
f Click the "Save" button.
f If necessary make the appropriate extended settings in the "Operator" menu.
f When the configuration is concluded, click the "Save & Restart" button.

6.2.6 Advanced settings

In the "Operator" menu, extended settings are provided under "Settings", in addition to the parameters.
The web interface includes several possibilities to make settings that the device does not support. In the sec-
tion "3 Product description" > "Equipment features" there is an overview of the device functions.
Block 1: Backend-System
Parameter
OCPP ChargeBoxIdentity
(ChargePointID)
Block 2: Backend-System, mobile telephony, network
Parameter
Connection Type
Access Point Name (APN)
APN username
APN Password
Description
Identification of the charging point that is
sent to the Backend-System
Description
Connection type to the Backend-System
Name of the access point of your mobile
access
Username for the access point of your
mobile access
Password for the access point of your
mobile access
Necessary Remark
for ...
Backend- The identification must
System be identical in the
Backend-System
Necessary Remark
for ...
Preset: "GSM"
„ Only relevant
Backend-
if "Connection
System /
Type" = "GSM"
Mobile tele-
„ Information is provi-
phony
ded by your Backend-
System operator.
EN
21