Operating Mode "Autostart; Operating Mode "Local Whitelist - Mennekes AMTRON Serie Manual De Instrucciones

Menu "Settings"
Basic settings can be made here, e.g.
„ Connection to a Backend-System
„ Maximum charging current
If necessary the presets defined in the menu "> Default"
can be restored through the button "Settings Default &
Restart".
Menu"> Default"
This is where presets for the "Settings" menu can be
defined.
Menu "Operator"
This is where all advanced settings for setting up the
device can be made, e.g.
„ Connection to a Backend-System
Menu "System"
Here you cannot make any settings. Information concer-
ning the firmware Version and the system are displayed. A
firmware update can be executed here.
Menu "Documentation"
Here you cannot make any settings. The interface docu-
mentation and error messages are described.

6.2.1 Operating mode "Autostart"

The device is operated as a stand-alone solution without
connection to a Backend-System. An authorisation is not
required. Charging starts automatically as soon as the
vehicle is plugged in.
f Navigate to the "Settings" menu and set the following
parameters:
Parameters
Connection Type
Free Charging
f When the configuration is concluded, click the "Save &
Restart" button.
Setting
f Select "No Backend".
f Select "On".

6.2.2 Operating mode "Local Whitelist"

The device is operated as a stand-alone solution without
connection to a master Backend-System. The authorisati-
on occurs through RFID cards and a Local Whitelist.
f Navigate to the "Settings" menu and set the following
parameters:
Parameters
Connection Type
Free Charging
If in doubt allow char-
ging
f Click the "Save" button.
Teach RFID cards by holding in front of RFID card rea-
der
f Navigate to the "Operator" menu and set the following
parameters:
Parameter Setting
Local fixed f Select "On".
authorization
list (FLL)
f Select "On".
FLL learning
mode The function remains active for 5
minutes
f Hold RFID cards in front of the RFID card reader one
after another.
The taught RFID UIDs (Unique Identifiers) are displayed
in the parameter "List of entries in FLL". A maximum of 80
RFID UIDs are displayed.
f When the configuration is concluded, click the "Save &
Restart" button.
Setting
f Select "No Backend".
f Select "Off".
f Select "Off".
EN
19