Cleaning And Maintenance - Babyauto BIRO 01 Manual De Uso

6. installinG tHe car seat. GrouP 1
notice
1. Ensure the seat is not in a reclined position (the indicator
should be in position 1) and is ready to install in forward
position (Group 1) as shown fig. 6.1. Pull the lever
and adjust the angle of recline to position 4 without releasing
the lever. If it is necessary swivel the seat 180º to place the seat
in the direction of travel (fig. 6.1.A). Release the lever when the
seat is in the desired position (fig. 6.1)
2. Place the child safety seat in the back seat of the vehicle
facing in the direction of travel (fig. 6.2).
3. Pass the vehicle seat belt through the slot on the back of the
safety seat
vehicle seat belt until you hear a click (fig. 6.4).
4. Take up the slack by pulling the abdominal section of the belt
until it is as tight-fitting as possible (fig 6.5).
6. Ensure the straps are not twisted at any point.
7. PlacinG tHe cHild in tHe seat. GrouP 1
To seat the child correctly follow the steps described in chapter 4.

8. cleaninG and Maintenance

1. To clean the straps and plastic elements of the seat use a
neutral detergent and warm water.
2. Make sure that soap does not enter the buckles or other
metallic elements.
3. Do not use chemical products or bleach on any part of the seat.
18
All manuals and user guides at all-guides.com
GROUP 1 only. From 9 months to 4 years
approx. (9-18 kg)
(m)
until it appears at the exit (fig. 6.3). Buckle the
(g)
forward