Publicidad
Idiomas disponibles
Idiomas disponibles
11. Pull the rotation system
position; this will make it easier for you to put your child in the safety
seat (fig. 5.9 y 5.10).
CAUTION! Before each journey, make sure that the rotation system has been
anchored correctly. Please also remember that the intermediate position is
only there to help you put your child in the safety seat; do not, under any
circumstances, start your journey with the safety seat in this position.
12. Loosen the harness by following the steps in Point 3.2 (fig 5.11).
13. Place the harness in slot B, if your baby weighs between 87 and 105 cm (fig 5.12).
14. Unbuckle the harness
the harness straps so that you can put your child in the safety seat
(fig. 5.13 and 5.14).
15. Put the child in the safety seat (fig 5.15) and put the harness on him/her.
16. Join the buckles and insert them into the harness until you hear a
click; this indicates that the safety seat has been secured properly
(fig. 5.16). Adjust the harness so that the shoulder straps
same level as the child's shoulders (fig. 5.17).
17. Pull the harness adjustment belt
snugly, without being too tight (fig. 5.18).
18. Pull the rotation system
the safety seat in forward-facing direction (fig. 5.19 and 5.20).
CLEANING AND MAINTENANCE
6.
1. Straps and plastic parts should be cleaned using a neutral detergent
and warm water.
2. Make sure soap does not enter the buckle or other metal parts.
3. Do not use chemical products or bleach on any part of the seat.
WASHING INSTRUCTIONS:
• The cover is removable and can
be washed at 30°. It should not
be machine dried.
• Machine wash – Cold cycle.
• Do not bleach.
28
(I)
until the safety seat is in the intermediate
(K)
by pressing the red button and open
(F)
so that it fits your child's body
(I)
to complete the installation, positioning
• For dry cleaning use
any solvent except
trichloroethylene.
• Do not use a drier.
• Do not iron.
(D)
are at the
30 °C
Publicidad
