Device Elements; Start Up; Operation - Kärcher IVR-L 100/30 Manual Del Usuario

Device elements

Illustration on the inside of the front
cover
1 Drain hose
2 Liquid reservoir
3 Push handle
4 Suction hose connection
5 Deflector plate
6 Power cord
7 Power switch
8 Crane point / eye hook
9 Display instrument
10 Lock suction head
11 Fine dust filter
12 Lever for lowering the collection con-
tainer
13 Accessories compartment
14 Guiding rolls with fixed position brake
Illustration on the inside of the front
cover
 Bring the appliance to working position
- secure it, if required, with parking
brakes.
 Ensure that the suction head has been
fitted properly.
Illustration
 Insert the suction hose into the suction
hose connection.
 Attach the desired accessories to the
suction hose.

Operation

Illustration on the inside of the front
cover
 Insert the mains plug into the socket.
Illustration
 Switch the device on at the power
switch
 Start suction process.
Note: When vacuuming up fluids, only im-
merse the accessories half way in order to
deliver sufficient air.
12

Start up

Display instrument
The created vacuum can be read on the in-
dicator.
 Clean or replace the filter in case of a
vacuum of less than 100 mbar.
See Chapter "Replacing the fine dust filter".
Check the fill level display
Note: The red marking on the drain hose
shows the maximum admissible filling lev-
el.
Empty the liquid container.
 Switch off the appliance and remove
the plug from the socket.
Illustration
 Lower the fluid container using the le-
vers.
 Pull the fluid container out of the device
holding the push handle
Note: Move the collection container on the
rollers, not by means of a forklift or crane.
Illustration
EN
– 3