After Use; General Safety Instructions - Cub Cadet 17AICBYQ603 Instrucciones De Funcionamiento Originales

Ocultar thumbs Ver también para 17AICBYQ603:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 109
EN
more than 9 %.
the following maximum values:
- Max. gradient 9%
- Max. support load on the trailer coupling 22 kg
- Max. trailer load (trailer and load) 113 kg

After use

switch off the engine. Always remove the igni-
tion key and engage the parking brake.
Ensure that ventilation slots are free from dirt.
Let the engine cool down before you store the
device.
Before carrying out any work on the mower
following prior to all performing work on the
device:
- Switch off the engine
- Remove the ignition key
- Engage the parking brake
- Wait until all rotating parts have come to a stand-
still
- Wait until the engine has cooled down
- Pull the spark plug connector off the engine so
that the engine cannot inadvertently start.

General safety instructions

Never let the engine run when in buildings or
poorly ventilated spaces. Risk of fatality due to
carbon monoxide poisoning!
Spare parts and accessories must satisfy the
You should therefore only use original spare
parts/accessories, or those which have been
approved by the manufacturer. Always observe
the installation instructions supplied with the parts
during replacement. The use of spare parts or
accessories not approved by the manufacturer
Have repairs performed exclusively by a
Do not carry passengers on the device. The
mower is not licensed for transporting people.
12
Safety information
This device is designed for looking after
grass and lawns in a domestic environment.
Due to dangers posed to the body of the user or
other persons, the device must not be used for
purposes other than those intended.
hand! Use a piece of paper or cardboard to do
this. Wear gloves and some protective goggles
when checking for leaks. If liquid gets into the
eyes, seek immediate medical attention. Never
conduct checks on the hydraulic system when
it is pressurised. Only ever have work on the
hydraulic system performed by a service centre.
Operate the unit in daylight or adequate
clean and well illuminated.
Ensure maintenance work is always
performed to schedule so that the mower
remains in a safe condition.
maintenance may lead to device damage and
thus to injury.
The engine and exhaust become hot and can
lead to buns. Do not touch!
Only use the mower in dry weather
conditions. Keep the mower away from rain or
dampness. If used on wet grass, the mower may
slip because of reduced adhesion.
Do not use the mower if it is raining or there
is a risk of storms.
Handle fuel with care. Fuel and petrol
vapour is explosive and petrol is extremely
engine is running or still hot. Only refuel the
mower outside. Store fuel in approved containers
only and never close to sources of heat (e.g.
heaters, stoves or hot-water boilers). Have a
damaged exhaust unit, fuel tank or fuel cap
replaced.
Do not start the engine if any petrol has been
spilt. Push the mower away from the area where
the petrol was spilt and wait until the petrol fumes
have evaporated.
hydraulic parts free from grass and leaking
oil.
Also follow the instructions in the engine
handbook.
Safety information
Keep your work area
769-12352

Publicidad

Tabla de contenido
loading

Tabla de contenido