Abicor Binzel iCAT WH Instructivo De Servicio página 31

iCAT WH
NOTICE
• Torsion A4 and A6 max. ± 355°.
Type of voltage
Polarity of the electrodes
Wire types
Type of use
Voltage rating
Protection type of the machine-side connections
(EN 60 529)
Shielding gas (DIN EN 14175)
Tab. 7
General torch data according to EN 60 974-7
The following data only apply in connection with the iCAT WH:
Type
Type of
cooling
ROBO WH W300 liquid
ROBO WH W500 liquid
ROBO WH W600 liquid
Tab. 8
Product-specific torch data (EN 60 974-7) in connection with iCAT
1Applications above 360A are possible in connection with the liquid-cooled torches
ROBO WH W500 using a special power-water-cable. It is available upon request.
2Use of the liquid-cooled ROBO WH W600 requires a special power-water-cable. With applications
above 500 A a cable assembly with two power-water-cables is available upon request.
The load data were determined under standard conditions, at low to medium heat of reflection,
free air circulation and an ambient temperature of approx. 28°C When used under more
strenuous conditions, the load data must be reduced by 10-20%.
Load Duty Wire
cycle
CO M21
2
A A % mm
320 300 100 0,8 - 1.2
1 1
360 340 100 0,8 - 1.6
2 2
500 500 100 0,8 - 1.6
3 Product description
ROBO WH
DC
Usually positive
Commercially available round wires
automatic
Peak value of 141 V
IP3X
CO or M21
2
Gas

flow
Cooling
capacity
min.
l/min W
ca. 20 800
10-20 800
10-20 800
Cooling data
Flow Flow
pressure
min. min. max.
l/min bar bar
1 1.5 3.5
1 1.5 3.5
1.5 1.5 3.5
EN - 9