Abicor Binzel iCAT WH Instructivo De Servicio página 44

10 Troubleshooting
9.2 Cleaning the clamping cylinder
1 2 3
5
1
Pneumatic connection
2
Cover
Fig. 13 Cleaning the iCAT WH ROBO WH
1 Unscrew clamping cylinder from the iCAT
2 Unscrew the pneumatic connection (1)
3 Unscrew the cover (2).
4 Blow compressed air through the individual parts.
5 Check the O-rings (6) for wear and replace them if necessary.
6 Grease the piston (4) and O-rings (6) with sealing grease (included in the scope of
delivery).
7 Mount clamping cylinder again
10 Troubleshooting
DANGER
Risk of injury and machine damage when handled by unauthorized persons
Improper repair work and modifications to the product may lead to serious injuries and dam-
age to the device. The product warranty will be rendered invalid if the unit is handled by
unauthorized persons.
• Only qualified personnel are permitted to perform work on the device or system.
Please observe the attached document "Warranty". Please consult your retailer or the
manufacturer in case of any doubts and/or problems.
NOTICE
• Consult the documentation for the welding components.
EN - 22
4 2
3
Housing
4
Piston
1 5 4
6
5
Connection seat
6
O-rings
iCAT WH
3