Abicor Binzel iCAT WH Instructivo De Servicio página 43

iCAT WH
9.1 Cleaning the adapter, WK and iCAT WH
1
Clamping cylinder
Fig. 12
DANGER
Risk of injury due to unexpected start
The following instructions must be adhered to throughout all maintenance, servicing,
assembly, disassembly and repair work:
• Switch off the power source.
• Close off the coolant supply.
• Close off the compressed air supply.
• Disconnect all electrical connections.
• Switch off the entire welding system.
1 Dismount the cable assembly
 6.4 Replacing the cable assembly on page EN-16
2 Clean the iCAT ROBO WH with compressed air.
3 Blow compressed air through the adapter.
4 Unscrew clamping cylinder (1) from the iCAT
5 Blow compressed air through the clamping cylinder bore
6 Blow compressed air through the wire conduit bore
7 Mount clamping cylinder and cable assembly again
1
adapter, WK and iCAT WH
Cleaning the
9 Maintenance and cleaning
EN - 21