Installing The Cooking Components; Placing The Grease Bucket; Connecting To A Power Source - Pit Boss PLATINUM LAREDO 1000 PB1000PL Instrucciones Y Recetas

Asador y ahumador de pellets de madera
Ocultar thumbs Ver también para PLATINUM LAREDO 1000 PB1000PL:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

13. INSTALLING THE COOKING COMPONENTS

Parts Required:
1
x
Top Cooking Rack (#1)
1
x
Middle Cooking Rack (#2)
2
x
Cooking Grids (#3)
Installation:
Place the cooking grids, side-by-side, on the grid ledges inside the
main barrel. Place the middle cooking rack on the middle ledge inside
the main barrel. Place the top cooking rack on the top ledge inside the
main barrel. The cooking racks will lock into place.
NOTE: To maintain the searing and grilling performance of your
cooking grids, regular care and maintenance is required.

14. PLACING THE GREASE BUCKET

Parts Required:
1
x
Grease Bucket (#18)
Installation:
Place the grease bucket on the spout hook on the end of the main
barrel. Ensure it is level to avoid grease spills.
The unit is now completely assembled.

15. CONNECTING TO A POWER SOURCE

STANDARD OUTLET
This appliance requires 110-120 volt, 60hz, 275W. It must be a 3-prong
grounded plug. Ensure grounded end is not broken off before use. The
control uses a 110-120 volt, fast-blow fuse to protect the board from
the ignitor.
GFCI OUTLETS
This appliance will work on most GFCI outlets, with a recommended
size of 15 amp service. If your GFCI outlet is highly sensitive to power
surges, it will likely trip during the start-up phase of operation. During
the start-up phase, the ignitor draws 200-700 watts of electricity
which can be too much power for a GFCI outlet to handle. Each time it
trips, it increases in sensitivity. If the GFCI keeps tripping, replace the
outlet or change to a non-GFCI outlet.
ON THE ROAD
Disconnect the ignitor from the main wiring harness. Use the manual
start-up procedure. A Pit Boss® unit can operate using a 12 volt,
100 watt inverter plugged into your automobile outlet. To use the
automatic ignitor, it is recommended to use a minimum of a 1000
watt inverter.
IMPORTANT: Disconnect unit from power source when not in use.
12
13
1
2
3
14
15
18

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

10712

Tabla de contenido