Mitsubishi Electric Mr. SLIM MSZ-FA25VA Technical Manual página 362

Funciones
MLZ-KA25VA
MLZ-KA35VA
MLZ-KA50VA
7-1. TIMER SHORT MODE
For service, set time can be shortened by short circuit of JPG and JPS on the electronic control P.C. board.
The time will be shortened as follows. (Refer to 9-7.)
Set time : 1-minute ➔ 1-second
Set time : 3-minute ➔ 3-second (It takes 3 minutes for the compressor to start operation. However, the starting time is
7-2. P.C. BOARD MODIFICATION FOR INDIVIDUAL OPERATION
A maximum of 4 indoor units with wireless remote controllers can be used in a room.
In this case, to operate each indoor unit individually by each remote controller, both the P.C. boards of remote controller
and the electronic control P.C. boards must be modified according to the number of the indoor unit.
How to modify the remote controller P.C. board
Remove batteries before modification.
The board has a print as shown below :
The P.C. board has the print "J1" and "J2". Solder "J1" and "J2" according to the number of indoor unit as shown in Table 1.
After modification, press the RESET button.
Table 1
No. 1 unit
No. 2 unit
No. 3 unit
No. 4 unit
How to modify the electronic control P.C. board
Turn OFF the power supply before modification. Cut off "JR05" and "JR06" on the electronic control P.C. board according
to the number of indoor unit as shown in Table 2. (Refer to 9-7.)
Table 2
No. 1 unit
No. 2 unit
No. 3 unit
No. 4 unit
NOTE : After modification, turn ON the power supply and with the remote controller headed towards the indoor unit, press the
OPERATE/STOP(ON/OFF) button. If one or two beeps is heard from the indoor unit, modification is completed
correctly.
362
shortened by short circuit of JPG and JPS.)
J1
1 unit operation 2 units operation
No modification Same as at left
–
–
–
JR05
No modification No modification
Cut off JR05 No modification
No modification
Cut off JR05
J2
3 units operation
Same as at left
Solder J1 Same as at left
–
–
JR06
VARISTOR (NR11)
Cut off JR06
Cut off JR06
NOTE : For modification, take out the bat-
teries and press the
OPERATE/STOP(ON/OFF) button
2 or 3 times at first.
After modification, put back the
batteries then press the RESET
button.
4 units operation
Same as at left
Same as at left
Solder J2 Same as at left
– Solder both J1 and J2
Indoor electronic
control P.C. Board
Fuse (F11)
JR06
JR05
IC101
T11
R111
C111
CN151
CN211