Securing The Front Panel To Support Legs; Mounting The Support Panels; Securing The Support Bar - Pit Boss PLATINUM BRUNSWICK PBV5PL Instrucciones Y Recetas

2. SECURING THE FRONT PANEL TO SUPPORT LEGS

Parts Required:
1 x Front Panel (#20)
1 x Ash Clean-out Housing (#10)
9 x Screw (#C)
Installation:
• Align the Ash Clean-out Housing in the center of the Front Panel
towards the underside of the unit (as shown in illustration). Secure
Ash Clean-out Housing to the underside of the unit with two screws.
Note illustration 2A.
• Mount the Front Panel to the Main Cabinet by using two screws. Next,
secure the Front Panel to the Left-Front Support Leg using two screws.
Repeat same installation for Right-Front Support Leg. Last, secure
the Front Panel to the Ash Clean-out Housing using one screw. Note
illustration 2B.

3. MOUNTING THE SUPPORT PANELS

Parts Required:
2 x Support Panel (#21)
8 x Screw (#C)
Installation:
• Install one Support Panel to the side of the unit between a Front and
Back Support Leg. Secure using two screws on each side. Ensure the
flat side of the Support Panel is facing outwards. Repeat the same
installation to mount the other Support Panel. Note illustration for
Support Panel arrangement.

4. SECURING THE SUPPORT BAR

Parts Required:
1 x Support Bar (#15)
2 x Screw (#B)
Installation:
• Install the Support Bar to the rear of the unit between the two Back
Support Legs. Secure using one screw on each side. Ensure the Support
Bar is placed on the underside of the Main Cabinet, facing inwards.
Note illustration for Support Bar arrangement.
8
2A
10
C
C
2B
20
C
3
C
C
C
C
C
C
21
4
B B
15
C
C
C
21