STAMOS S-LS-96 Manual De Instrucciones página 38

d) Use caution and common sense when operating this device. A moment's
inattention during operation may result in serious personal injury.
e) The unit is not a toy. Children should be watched to ensure that they do not
play with the unit.
2.4. Safe use of the unit
a) Do not overload the unit. Use tools that are suitable for the application. A
correctly selected unit will do a better and safer job for which it was designed.
b) Do not use the device if the ON/OFF switch does not function properly (does
not turn on and off). Units that cannot be controlled by the switch are unsafe,
cannot operate, and must be repaired.
c) Disconnect the unit from the power supply before adjusting, cleaning, or
servicing. This precaution reduces the risk of accidental start-up.
d) Keep unused equipment out of the reach of children and out of the reach of
anyone unfamiliar with the unit or this instruction manual. These units is
dangerous in the hands of inexperienced users.
e) Keep the unit in good working condition. Check before each use for general
damage or damage to moving parts (cracks in parts and components or any
other condition that may affect the safe operation of the unit). If damaged,
have the unit repaired before use.
f) Repairs and maintenance should be carried out by qualified personnel using
only original spare parts. This will ensure the safety of use.
g) To ensure the designed operational integrity of the unit, do not remove
factory-installed covers or loosen screws.
h) Do not move, shift, or rotate the machine while in operation.
i) Do not leave the unit switched on unattended.
j) Clean the unit regularly to prevent permanent dirt build-up.
k) The unit is not a toy. Cleaning and maintenance must not be performed by
children without adult supervision.
l) Do not tamper with the unit to alter its performance or design.
m) Keep the unit away from sources of fire and heat.
n) Do not block the ventilation openings of the device!
o) Do not use the power supply under full load for a long time, it may cause
damage to the device.
p) The output voltage of the Power Supply should not exceed the input voltage
of the device being powered. Too high a voltage can damage the device.
q) Before changing the operation mode of the Power Supply, first disconnect the
external load cables connected to it.
r) If the unit is operating with an inductive load such as magnetic coils, DC
motors, stepper motors, etc., be sure to change the voltage/current slowly.
NEVER turn the power on or off with an inductive load connected.