46
ENGINE OPERATION
ENOW00057-0
CAUTION
Do not tilt up outboard motor while engine
operates, or no cooling water may be fed,
leading to engine seizure due to overheat-
ing.
2. Lock the tilt with the Tilt stopper after
the outboard motor has been tilted up.
1
1. Tilt stopper
If the battery is dead, and the power
trim & tilt switch thus inoperative, turn
the manual valve a few turns in the Man-
ual direction. This will allow manual tilt-
ing of the outboard motor.
1. POWER
2. MANUAL
ENOM00055-0
EFT, EPT type
The provided Power tilt makes tilt-up/
down electrically. It may be used as a
power trim and tilt when the outboard
motor is used with the light load condition.
In this case, it can be adjusted to set the
desired trim angle of the outboard motor in
relation to the transom shape, planning
speeds and load. It is imperative that the
trim angle is adjusted correctly. Incorrect
adjustment will cause the boat to sway,
deteriorate engine performance and may
cause unsafe steering conditions.
ENOW00045-0
ENOF00069-0
The Power Trim & Tilt can be set to any trim
angle, however, avoid cruising with the out-
board motor tilted in the tilt range. Operat-
ing the boat in this manner, the outboard
motor may ingest air into the water cooling
system, resulting in engine overheating.
1
2
ENOF00326-0
CAUTION