Introduction - SOMFY LT 50 CSI RTS Guia De Instalacion

EN
CONTENT
1. Introduction
2. Safety
2.1. General safety advice
2.2. Operating conditions
3. Installation
3.1. Motor preparation
3.2. Tube preparation
3.3. Motor/tube assembly
3.4. Fitting the adjustment pull tabs (optional)
3.5. Fitting the emergency crank
3.6. Fitting the motorised tube
3.7. Wiring
4. Commissioning
4.1 Programming the RTS control point
4.2 Checking the direction of rotation
4.3 Adjusting the end limits
4.4 Checking the settings
4.5 Fitting the protective housing
5. Parameter setting
5.1 Adding/Deleting RTS and RT control points
5.2 Adding/Deleting RTS sensors
5.3 Setting intermediate positions
6. Operation
6.1 Using intermediate positions
6.2. Operating the emergency crank
7. Resetting
7.1 With an RTS control point programmed in the motor.
7.2 With a new RTS control point
8. Technical specifications

1. INTRODUCTION

The LT 50 CSI RTS motor is designed to drive a roller shutter or awning.
It is equipped with a back-up system used to open and close the roller shutter or awning in the event of a
power outage: the roller shutter or awning can be manually opened and closed using a special integrated
crank.
The upper and lower end limits of the motor can be adjusted using push-buttons. The push-buttons are
covered by a protective housing which ensures the motor head is sealed when installed outdoors with the
push-buttons facing upwards.
14
Copyright © 2007-2020 SOMFY ACTIVITÉS SA, Société Anonyme. All rights reserved.
LT 50 CSI
14
15
15
15
15
15
15
16
16
16
16
16
17
17
17
17
18
18
19
19
19
19
21
21
21
21
21
22
22