With A New Rts Control Point; Technical Specifications - SOMFY LT 50 CSI RTS Guia De Instalacion

EN

7.2 With a new RTS control point

N.B.: This reset deletes all control points and sensors programmed, but the intermediate positions are
retained.
N.B.: Only switch off the current for the motor to be reset!
N.B.: Do not use the Inis RT/Inis RTS control point for resetting!
- Place the roller shutter/awning in the mid-height position
- Cut the power supply for 2 seconds.
- Switch the power supply back on for 5 to 15 seconds.
- Cut the power supply for 2 seconds.
- Switch the power supply back on: the roller shutter/awning
moves for a few seconds.
Caution : if the roller shutter/awning is in the upper or lower end
limit position it will move up and down briefly.
- Press the RTS new control point PROG button until the
motor moves for a few seconds:
► all the RTS control points and RTS sensors are
cleared and
► the new RTS control point is programmed in the
motor.
- Follow the procedures in the «Parameter setting» section
to RTS control points and RTS sensors.

8. TECHNICAL SPECIFICATIONS

Operating temperature
Protection rating
Maximum number of connected control points
Maximum number of connected sensors
22
Frequency
Power supply
Copyright © 2007-2020 SOMFY ACTIVITÉS SA, Société Anonyme. All rights reserved.
5 s <
2 s
LT 50 CSI RTS
433,42 MHz
230 V - 50 Hz
- 20 °C à + 70 °C
IP 44
12
3
LT 50 CSI
<15 s
2 s
IP
LT 50 CMO RTS
433,42 MHz
120 V - 60 Hz
- 4 °F à + 158 °F
IP 44
12
3