Controls, Alarms And Indicators; Control Panel With Typical Lcd Screen View In Run Mode; Lcd Screen Icons; Power Button - arjo Flowtron ACS900 Instrucciones De Uso

3. Controls, Alarms and Indicators

Control Panel with Typical LCD Screen View in Run Mode

LCD Screen
Left Control Button

Power Button

and Mains Indicator
Middle Control Button
To switch the pump on:
• Connect the pump to mains power and the pump
will run its internal diagnostic tests and go to
Standby (refer to "Standby Screens" on page 14).
• If the pump is already connected to mains power,
press and hold the Power button for approximately
2 seconds, and the pump will go directly to Standby.
• If the pump is not connected to mains power, press
and hold the Power button for approximately 2
seconds, and the pump will run its internal
diagnostic tests and go to Standby.
The Mains indicator above the Power button shows the
mains power status of the pump:
• Not illuminated: mains power is disconnected.
• Illuminated green: mains power is connected to the
pump.
To switch off the pump, press and hold the Power
button for approximately 2 seconds. Then,
• If the pump is connected to mains power, the LCD
screen backlight will be extinguished and only the
mains power and battery indication icons will be
displayed. Release the button.
• If the pump is not connected to mains power, the
pump will power down and the LCD screen will be
blank. Release the button.
8
Mains Indicator
Power Button
Right Control Button