Operation; General; Installing The Pump; Start Up - arjo Flowtron ACS900 Instrucciones De Uso

4. Operation

General

Installing the Pump 1. The pump should be placed feet down on any

Start Up

Mains Power Connected
These instructions cover the routine operation of the
system. Other operations, such as maintenance and
repair, should only be carried out by suitably qualified
personnel.
Refer to "Controls, Alarms and Indicators" on page 8
for a description of the controls, indicators and LCD
screen.
NOTE
If the operation or performance of the pump changes
during use, refer to "Troubleshooting" on page 25 of
this IFU before calling a service engineer or
contacting your local Arjo sales office.
convenient horizontal surface or alternatively
suspend the unit with the use of bed hooks
(integral hanging brackets).
2. Beyond placing the pump on the bed frame or on
the floor, the use of IV Pole Bracket or Wall
Bracket should be considered.
3. Depending on the therapy environment, the pump
may also be secured with the use of alternative
solutions, such as the additional bracket mounted
to the bed frame. The appropriate solution should
be chosen to ensure patient safety.
1. To switch on the pump, do one of the following:
• Connect the pump to the mains power supply
using the power cable provided.
• If this product is used for the first time, connect
the pump to the mains power supply to activate
the internal battery.
• If operating on battery (the pump is
disconnected from the mains power supply),
press the Power button.
2. The pump will power up automatically and start
running a diagnostic test and initialising the pump.
One of the following screens will be displayed,
with a rotating 6-segment circular icon:
13
Mains Power Disconnected