Stopping Therapy - arjo Flowtron ACS900 Instrucciones De Uso

Ocultar thumbs Ver también para Flowtron ACS900:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Stopping Therapy

If calf (or calf & thigh) garments are attached to the
pump, then each of these garments is inflated to the
target pressure, with an inflate time of 12 seconds and
a deflate time of 48 seconds.
If a foot garment and a calf (or calf & thigh) garment are
attached to the pump, then since the inflate and hold
times for a foot garment are shorter than for a calf (or
calf & thigh) garment, there is a modified inflation
sequence: the foot garment is always inflated twice in
succession and then the calf (or calf & thigh) garment
is inflated, as follows.
1. Inflate the foot garment.
2. Deflate the foot garment.
3. Repeat the inflation of the foot garment.
4. Deflate the foot garment.
5. Inflate the calf (or calf & thigh) garment.
6. Deflate the calf (or calf & thigh) garment.
7. This cycle of garment inflations repeats from step
1 until the therapy is stopped.
To stop the therapy and put the pump into Standby,
press and hold the Middle Control button for
approximately 2 seconds until the Standby screen is
displayed (refer to "Standby Screens" on page 14) and
then release it.
The LEDs on the front and underside of the pump are
extinguished.
If the pump stays in Standby, then:
1. After 5 minutes the LCD display backlight is
dimmed.
2. After a further 10 minutes (15 minutes total) the
pump automatically goes into an "Off" state:
• On mains power, the LCD screen backlight will
be extinguished and only the mains power and
battery indication icons will be displayed.
• On battery power, the pump will power down
and the screen will be blank.
NOTE
The Mains indicator above the Power button will
remain green if the pump is connected to the mains
power and extinguished if the mains power is
disconnected.
To switch off the pump, press and hold the Power
button for approximately 2 seconds. Then,
• On mains power, the LCD screen backlight will be
extinguished and only the mains power and battery
indication icons will be displayed.
• On battery power, the pump will power down and
the screen will be blank.
18

Publicidad

Tabla de contenido
loading

Tabla de contenido