Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Middle Control Button
Left Control Button
Right Control Button
LCD Screen Icons This screen shows the position and description of all
Garment
Low Pressure/
Pressure
Leak
Indication
Garment Type
and Inflation
Indication
Tubeset
Connector
Number
Audible
Alarm
Muted
Audible
Audible Alarm
Alarm Status
When the pump is in Standby and one or two garments
are connected, press this button to put the pump into
the Run mode and start therapy; the LED indicators on
the front and underside of the case will be illuminated
green.
To stop the therapy and put the pump into Standby,
press and hold this button for approximately 2 seconds
until the Standby screen is displayed and then release
the button. The LED indicators on the front case will be
extinguished.
If an audible alarm sounds during therapy, press this
button to mute the audible alarm.
NOTE
Only certain alarms can be muted.
NOTE
Refer to "Troubleshooting" on page 25 for details of
the various alarm conditions and possible corrective
actions to rectify the faults.
When the pump is in Standby, press this button to
change the alarm volume (refer to "To Change the
Audible Alarm Volume Setting" on page 20).
Press this button to reset the Therapy Time. This can
be done either at power up, after the pump has
initialised or if the therapy is stopped and the pump is
in Standby (refer to "Resetting the Therapy Time" on
page 20).
possible icons which can be displayed. The actual
icons which will be displayed will depend on the pump
status, patient therapy and whether a fault has been
detected.
Kinked/
Blocked Tube
Start/Stop
Volume
Therapy
Mains Power
Not Connected
Garment Removed Time
Wait/
High Temperature
Initialising
9
Mains Power
Connected
Battery Level
Indication
Warning/Alarm
Indication
Hardware Fault/
Service Required
Therapy Time/
Alarm
Publicidad
Tabla de contenido
