Tabla de contenido
Publicidad
All manuals and user guides at all-guides.com
Information!
The SATAminijet version has a
small grooved pin for aligning the
air nozzle.
■ Screw in paint nozzle [5-8] using
SATA universal wrench.
■ Attach air nozzle ring [5-10] together
with air nozzle [5-9] and screw on by
hand. Pay attention to desired nozzle
position and alignment of notches in
air nozzle in relation to grooved pin
[6-1] (not on SATAminijet).
■ Insert paint needle [5-7].
■ Install both springs [5-5], [5-6].
■ Screw on end cap [5-4].
■ Install spring [5-3].
■ Insert control cap [5-1] into nozzle
head [5-2].
■ Screw on control cap.
■ Readjust the material flow rate pa-
rameters using the dials (see Chap.
9.2).
10.2. Replace air distribution
ring
Perform all work steps described
in the Chapter Replace nozzle set
before and after replacing air distri-
bution ring (see Chap. 10.1).
Operating Instructions for SATA LAB Automatic Guns
Remove air distribution ring
The air distribution ring is lodged
tightly in the nozzle head. Use of
too much force can damage the
nozzle head. Slipping with the
SATA extraction tool can lead to
injury.
→ Wear work gloves.
→ Always use SATA extraction
tool pointing away from your
body.
→ Pull air distribution ring evenly
out of nozzle head.
■ Perform work step 'Remove nozzle
■ Pull out air distribution ring [7-1] using
■ Check sealing surfaces for damage
Install new air distribution ring
■ Insert air distribution ring [8-3] into
■ Press air distribution ring in evenly.
■ Perform work step 'Install new nozzle
Notice!
set' (see Chap 10.1).
SATA extraction tool [7-2].
and contamination, clean or replace
as required.
nozzle head [8-2]. Ensure that the
lug at the bottom of the air distribution
ring is aligned properly [8-1].
set' (see Chap 10.1).
US
427
Publicidad
Tabla de contenido
