Power Stroke PSi2000B Manual Del Operador página 11

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

FUEL CAP WARNING
Never remove fuel cap when unit is running.
Shut off engine and allow the unit to cool at least
five minutes. Remove cap slowly to release any
pressure built up in the fuel system and to avoid
the heat from the muffler igniting fuel vapors.
ENGINE LUBRICANT WARNING
You must add lubricant before first operating the generator.
Always check the lubricant level before each operation. The
lubricant level should always register between the hatched
areas on the dipstick. The unit is equipped with a sensor which
will automatically shut off the engine if the lubricant level falls
below a safe limit.
GROUNDING WARNING
This generator does not include
a ground rod or copper wire. Call
a qualified electrician for local
grounding requirements.
HOT SURFACE WARNING
Do not touch the muffler or alu-
minum cylinder of the engine. They are very HOT
and will cause severe burns. Don't put any flam-
mable or combustible materials in the direct path
of the exhaust.
SPARK ARRESTOR
Operation of this equipment may create sparks that
can start fires around dry vegetation. A spark arrestor
may be required. The operator should contact local
fire agencies for laws or regulations relating to fire
prevention requirements.
CLEARANCE WARNING
While operating and storing, keep at least 3 feet of clear-
ance on all sides of this product, including overhead.
Allow a minimum of 30 minutes of "cool down" time
before storage. Heat created by muffler and exhaust
gases could be hot enough to cause serious burns
and/or ignite combustible objects.
SYMBOLS
Page 7 — English
DANGER
PELIGRO
RISQUE D'INCENDIE ET DE BLESSURES GRAVES : Ne jamais retirer le
capuchon du réservoir d'essence pendant que l'appareil fonctionne.
Éteindre le moteur et laisser refroidir l'appareil pendant au moins
cinq minutes. Retirer lentement le capuchon.
RIESGO DE INCENDIOS Y LESIONES POR QUEMADURAS: Nunca retire la tapa
de combustible mientras esté encendida la unidad. Apague el motor y deje
enfriar la unidad durante al menos cinco minutos. Retire la tapa lentamente.
UTILISEZ UN STABILISATEUR DE CARBURANT POUR LE STOCKAGE
EL USO DEL ESTABILIZADOR DE COMBUSTIBLE PARA EL ALMANCENAMEIENTO

Publicidad

Tabla de contenido
loading

Tabla de contenido