Stihl FS 565 Manual De Instrucciones página 24

English
STIHL TrimCut 31-2,
STIHL FixCut 25-2,
STIHL PolyCut 20-3
1
N Screw the mowing head
counterclockwise on to the shaft (1)
as far as stop.
N Block the output shaft
N Tighten down the mowing head.
Remove the tool used to block the
shaft.
22
STIHL FixCut 25-2 (early version)
N Place the mowing head on the
thrust plate (2).
Collar (see arrows) must engage
the mowing head's mounting hole.
N
Push the thrust washer (3) over the
shaft (1) so it is seated on the base.
N Block the output shaft
N Use the combination wrench (5) to
screw the mounting nut (4) onto the
output shaft and it tighten down
firmly.
Remove the tool used to block the
shaft.
Removing the mowing head
N
Block the output shaft
STIHL SuperCut 20-2,
STIHL AUTOCUT 25-2,
STIHL AUTOCUT C 25-2,
STIHL TrimCut 30-2,
STIHL TrimCut 31-2,
STIHL FixCut 25-2,
STIHL PolyCut 20-3
N Unscrew the mowing head
clockwise.
STIHL FixCut 25-2 (early version)
N Use the combination wrench to
loosen and unscrew the mounting
nut clockwise from the output shaft.
If the mounting nut has become
too loose, fit a new one.
Adjusting nylon line
STIHL SuperCut
Fresh line is advanced automatically if
remaining line is still at least 2.4 in
(6 cm) long. The blade on the deflector
trims surplus line to the correct length.
STIHL AUTOCUT
N Hold the rotating mowing head
above the ground – tap it on the
ground once – about 1.2 in (3 cm)
fresh line is advanced.
The blade on the deflector trims surplus
line to the correct length – avoid tapping
the mowing head more than once at a
time.
Line feed operates only if both lines still
have a minimum length of 1 in (2.5 cm).
FS 56, FS 56 R, FS 56 C, FS 56 RC