Stihl FS 565 Manual De Instrucciones página 23

Mounting hardware for cutting
attachments
The mounting hardware supplied
depends on the cutting attachment that
comes as original equipment with the
new trimmer/brushcutter.
Mounting hardware is not packed
with machine
2
Only mowing heads may be used which
mount directly to the shaft (2).
Mounting hardware is packed with
machine
Mowing heads and metal cutting blades
may be mounted.
FS 56, FS 56 R, FS 56 C, FS 56 RC
3
4
5
The nut (3), rider plate (4) and thrust
washer (5) are required to secure some
mowing heads.
These parts are included in a kit
supplied with the machine and are also
available as special accessories.
Blocking the output shaft
2
8
7
The output shaft (2) must be blocked
with the stop pin (7) or screwdriver (7) to
mount or remove cutting attachments.
These parts come standard with the
machine or are available as special
accessories.
N
Insert the stop pin (7) or
screwdriver (7) in the hole (8) in the
gearbox as far as stop – and apply
slight pressure.
N Rotate nut or cutting attachment on
the shaft until the stop pin slips into
position and blocks the shaft.
Mounting the cutting attachment
N Go to "Mounting the mowing head"
or "Mounting the metal cutting
blades".
Mounting the mowing head
Keep the instruction sheet for the
mowing head in a safe place.
STIHL SuperCut 20-2,
STIHL AUTOCUT 25-2,
STIHL AUTOCUT C 25-2,
STIHL TrimCut 30-2,
7
English
21