Stihl FS 565 Manual De Instrucciones página 25

All other mowing heads
Refer to the instructions supplied with
the mowing head.
To reduce the risk of injury, always
shut off the engine before
adjusting the mowing line by
hand.
Replacing nylon line or cutting
blades
Refer to the instructions supplied with
the mowing head.
Mounting Metal Cutting Blades
If you want to use a grass cutting
blade, mount the deflector for
grass cutting blades – see
"Mounting the Deflector".
Check direction of rotation of metal
cutting blade
1
Cutting edges of grass cutting blade (1)
may point in either direction.
Cutting edges of grass cutting blade (2)
must point clockwise.
Direction of rotation is indicated by
an arrow on the inside of the
deflector.
FS 56, FS 56 R, FS 56 C, FS 56 RC
N Place the cutting attachment (4) on
the thrust plate (5).
Collar (see arrow) must engage
the mowing head's mounting hole.
Securing the cutting attachment
N
Fit the thrust washer (6) and rider
plate (7) on the shaft (8).
N Block the shaft and screw the
mounting nut (9) on to the shaft
counterclockwise and tighten it
down firmly.
If the mounting nut has become
2
too loose, fit a new one.
Removing the metal cutting blade
N
N
N
9
7
6
4
8
5
Block the output shaft
Unscrew the mounting nut
clockwise.
Take the parts off the shaft – do not
remove the thrust plate (5).
English
23