Installation Instructions; Transport/Unpacking; Product Environment; Choice Of A/B Version - aldes InspirAIR Top Serie Instrucciones De Instalación

4. INSTALLATION INSTRUCTIONS

4.1. Transport/unpacking

On receipt of the product, verify its condition and record any remarks for the attention of the delivery company on the delivery slip. The delivery includes at least:
- The unit and a wall fastening system
- Documentation
- A connector to fix the water trap to the unit (the water trap is sold as an accessory)
Remove the banding from the product. Lift the upper cardboard cover.
Important: Do not handle the product by its connections.
The permitted storage and transport temperature is between -20°C and +60°C. Transport and unpack the unit carefully.
Important: the installer is responsible for recycling the product packaging.

4.2. Product environment

The product and the ducts must be installed in a heated room to guarantee optimal thermal performance and to avoid condensation from forming in areas
designed to drain it properly. The system must not be installed in a room where there is a risk of explosion due to gases, emissions or dust. Provide for condensate
discharge with a water trap (water trap sold as accessory). It is not recommended to install the unit in places with high humidity level. The electrical installation
must be adapted to the maximum power of the unit (see point 3.2). The location and fastening must ensure minimum maintenance access.

4.3. Choice of A/B version

The product is delivered by default in configuration A (
To convert it physically to configuration B (
- Break tab "B" at the rear of the cable tray and clip it over the A (
- Reverse the two filters (see procedure and details of references §6.1).
- Confirm this configuration in the remote control or Configurator software program.
- Connect the condensate discharge of the corresponding side (A or B) (
Only for the Exhausto codes with humidity sensors:
Also move the humidity probe from side A to side B (
the sensor from the sealing foam placed under the A and replace it in one of the cable feedthrough locations in the sealing foam side B.
1
).
1
):
2
).
3
).
4
): the humidity sensor has to be replaced dwelling side. To do this, open the front panel, carefully remove
3
2 3
18
550 mm
4