Safety Instructions - aldes NanoAIR 50 Instrucción De Instalación

1. SAFETY INSTRUCTIONS

Comply with the requirements of the User Guide and of all local and national electrical and technical construction standards applicable.
All connection, servicing and repair operations on the device must be carried out with the equipment powered off (disconnected).
Only specialists with the right to work on electrical installations up to 1000 V after reading these instructions must service and assemble the
equipment.
Before installation, make sure that the motor, box and grille are not damaged and that there are no foreign bodies in the flow section of the box that
could damage the impeller blades.
Do not overtighten the box when assembling the device! Damage to the box can cause the fan to jam and make a loud noise.
It is prohibited to use the device for inappropriate purposes or to modify it.
Do not expose the device to detrimental atmospheric influences (rain, sun, etc.).
The ventilated air must not contain dust, solid particles or viscous and fibrous matter.
Do not use the equipment in an environment containing flammable substances or vapours, for example, alcohol, petrol, insecticide, etc. There must
be a constant flow of air in the room for the device to run smoothly. Do not close or plug the exhaust and air intake holes on the equipment to avoid
preventing the optimum passage of the air.
Do not sit on the equipment or place objects on it.
The information indicated in this Manual is correct at the time of preparing the document. As it is constantly upscaling its devices, the Company
reserves the right to alter the technical characteristics, layout or configuration of the Device at any time.
No part of this publication may be reproduced, transmitted or saved in information and research systems, nor translated into other languages in any
form whatsoever without the written agreement of the Company.
As with the use of any other domestic electrical equipment, compliance with the rules listed below is essential when using this device:
• Never touch the device with wet or damp hands;
• Never touch the device when barefoot.
The equipment is not designed to be used by people (including children) with impaired physical, sensory or mental capacities, or with no experience
or previous knowledge, unless they are supervised or instructed in using the equipment by a person responsible for their safety.
Children must be supervised to ensure that they do not play with the equipment.
The equipment must be connected to the power supply by a disconnect device with contact cut-off at all poles, which ensures full disconnection in
Category III overvoltage conditions, incorporated into the fixed cabling in accordance with electrical installation rules.
Any damaged power lead must be replaced by the manufacturer, the after-sales service or similarly qualified persons to prevent a hazard.
Make sure that the equipment is disconnected from the power supply before removing the guard.
Precautions must be taken to avoid the backflow of gas in the room from open fireplaces or fuel-burning equipment.
A device reaching its end of life must be recycled.
Do not throw the device away with non-sorted household waste.
EN
19