Nilfisk Advance Proterra Instrucciones De Uso página 32

TROUBLESHOOTING
SCRAPPING
ENGLISH
30
(*) Procedure to be performed by Advance Service Center.
For further information, refer to the Service Manual, available at any Advance Service Center.
Before scrapping the machine, remove and separate the following materials, which must be disposed of properly according to the
Law in force:
– Batteries
–
– Main and side brooms
– Hydraulic system oil
–
– Plastic hoses and components
– Electrical and electronic components (*)
(*) Refer to the nearest Advance Service Center especially when scrapping electrical and electronic components.
Trouble
The machine does not move
The main broom does not turn
The machine collects little debris/dust
The side broom does not operate
The hopper dumping door does not close
The DustGuard™ system (optional) does
not work
The filter shaker motor does not work
Have the machine scrapped by a qualified scrapper.
Polyester dust filter
Hydraulic system oil filter
INSTRUCTIONS FOR USE
Proterra™ - 33019867
Possible cause
The batteries or the connector are
disconnected
The batteries are discharged
The fuses are tripped
The parking brake is engaged
The unlocking screw is not in a proper position Turn it properly
The main broom is lifted
Debris wrapped around the broom drive
The hopper is not fully lowered
The hopper is full
The skirts are damaged or misadjusted
The main broom height is incorrect
The fuses are tripped
The side broom is lifted
Debris wrapped around the broom drive
The hopper is not fully lowered
The dumping door is jammed by debris
properly connected
The fuse is tripped
The switch is faulty
The pump is faulty
The fuse is tripped
The vacuum system is off
The dust filter is clogged
The filter shaker motor connector is not
The nozzles or the water filter are clogged
Remedy
Connect the batteries or the connector
Charge the battery
Reset any tripped fuse
Disengage
Lower the main broom with the lever
Remove debris
Fully lower the hopper
Turn on the vacuum system with the switch
Empty the hopper
Check the skirt for integrity and proper adjustment (*)
Adjust the main broom height
Reset any tripped fuse
Lower the side broom with the lever
Remove debris
Fully lower the hopper
Remove debris and clean edges of dirt chamber
Connect it properly
Reset the tripped fuse
Replace the switch (*)
Clean
Replace
Reset the tripped fuse
Clean the dust filter
revised 08/2018
09/2010