Parking Brake; Sweeping - Nilfisk Advance Proterra Instrucciones De Uso

PARKING BRAKE

SWEEPING

revised 08/2018
09/2010
1. Engage the parking brake by pressing the pedals (35) and (36) simultaneously.
2. Disengage the parking brake by pressing and releasing the pedal (35).
WARNING!
Follow the instructions in Preparing The Machine For Use paragraph.
1. Drive the machine to the work area as shown in the previous paragraph.
2. Check that the hopper has been properly lowered with the lever (54).
3. Start cleaning by lowering and using the main broom with the lever (53).
CAUTION!
Avoid stopping for a long time with the machine in the same position and the brooms turning: this could create
NOTE
The hopper dumping door opens automatically when the main broom lowers and closes automatically as soon as the
main broom is lifted.
4. Press the upper part of the switch (59) to turn on the vacuum fan and the dust guard system.
CAUTION!
5. Lower and turn on the side brooms (9) (15, optional) with the lever (52).
If equipped, turn on the DustGuard™ system with the switch (60).
6. Drive the machine straight forward at a quick walking speed. Drive the machine slower when sweeping large amounts of dust
or debris or when safe operation dictates slower speeds. Overlap passes 5.9 in (15 cm).
7.
the upper part of the switch (59) after shaking has completed.
While working, repeat the procedure every 10 minutes on average (depending on the dustiness of the area to be cleaned).
NOTE
This procedure can also be performed when the machine is moving.
CAUTION!
8. Check behind the machine occasionally to make sure that the machine is picking up debris. Dirt left behind in the path of the
machine usually indicates that the machine is moving too fast, the main broom needs to be adjusted, or the hopper (45) is full.
The hopper (45) should be dumped after each working period and whenever it is full (see the procedure in the next paragraph).
Before performing any maintenance, repair, cleaning or replacement procedure engage the parking brake.
Always engage Parking Brake before Servicing and when parking machine on an incline.
unwanted signs on the floor.
When working on wet floors, turn off the vacuum fan and the dust guard system with the switch (59) to preserve
the dust filter.
Turn on the vacuum fan and the dust guard system as soon as the machine returns to a dry floor.
For proper machine operation, the dust filter must be as clean as possible. To clean the dust filter while sweeping, turn on the
filter shaker by pressing the lower part of the switch (59), then turn on the vacuum fan and the dust control system by pressing
When the dust filter is clogged and/or the hopper is full, the machine cannot collect dust and debris anymore.
INSTRUCTIONS FOR USE
33019867 - Proterra™
ENGLISH
17