Assembling Your Breast Pump; Selecting The Correct Breast Shield Size; Assembling The Collection Cups - Medela Freestyle Hands-free Instrucciones De Uso

7. Assembling your breast pump

Only use clean and dry parts for assembly. Refer to chapter 6 for cleaning.

7.1 Selecting the correct breast shield size

Make sure to use the correct breast shield size. It is an essential component of effective
pumping, helping to optimize milk flow.
Refer to figure ¢6 on the foldout pages.
1. Select the breast shield size by measuring the diameter of your nipple ( ¢6-01).
2. Select the breast shield size that is slightly larger than your nipple ( ¢6-02).
21 mm and 24 mm size shields are included in the pack.
For more information on breast shield sizing and other available sizes, visit www.medela.com
or see chapter 13 for ordering information.

7.2 Assembling the collection cups

Only use clean and dry parts for assembly. Refer to chapter 6 for cleaning.
Parts needed:
• Tubing
• Breast shield
• Motor unit
CAUTION
To prevent contamination of your milk:
• Wash hands thoroughly with soap and water before touching the motor unit, parts of the
collection cups and breasts.
• Dry your hands with a fresh towel or a single-use paper towel.
• Avoid touching the inside of the collection cup components.
To make sure that your breast pump works properly and safely:
• Check collection cup components for wear or damage before use. Replace if necessary.
• Always inspect all parts prior to use for cleanliness. If dirty, clean according to chapter 6.
• Only use genuine Medela parts. See chapter 13 for details.
NOTICE
To prevent damage to the breast pump, all components must be completely dry
before use.
• Yellow membrane
• Outer shell
17