SECTION 3
3.7
Secondary Output Connections for Manual Cutting
WORK
WArNINg
3.8
PT-38 Torch Installation
1.
Open torch lead access door on the front panel of the Powercut-1300/1600.
SAFETY
GROUND
MAKE SUrE POWEr SWITCH ON CONSOLE IS IN Off POSITION AND
PrIMArY INPUT POWEr IS DE-ENErgIZED.
The PT-38 torch comes factory installed with the
manual packages.
Clamp the work cable to the workpiece. Be sure
the workpiece is connected to an approved earth
ground with a properly sized ground cable.
PT-38 Cutting Torch
figure 3-3. Powercut Interconnection Diagram
Torch Lead
Access
Door
114
INSTALLATION