Door Removal And Reinstallation - Midea MGS30S2AST Instrucciones De Instalación

Door Removal and Reinstallation:

WARNING
FIRE HAZARD
• If door is removed, confirm that door operates correctly and seals
properly when reinstalled. If door gasket does not seal completely,
heat escaping from around doors could ignite cabinetry.
During installation, service, gas conversion, and leveling, it may be easier
to perform the necessary work if the oven door is removed. This makes
the appliance lighter and access to the oven cavity easier. Follow these
instructions below to remove and reinstall the door.
Door can be removed for easier cleaning, servicing, or installation:
1. Open door fully.
2. On each door hinge, flip down the lock mechanism so that it engages
with the door when the door is rotated towards being closed.
3. Once both lock mechanisms are engaged, continue to rotate door
until ~2-3 inches from being fully closed.
4. Grasp door firmly from the sides and lift door up and out from oven face.
Do not lift door by door handle to reduce risk of broken door glass.
Reinstalling door:
1. Holding door from the sides, align door so that hinges slip back into
openings.
2. Rotate door until ~2-3 inches from being fully closed, allow door to drop
into notches on hinges.
3. Rotate door out until fully open.
4. Flip the hinge locking mechanism back up and away from the door.
5. Check that door opens and closes correctly.
6. If door does not operate correctly, re-engage locking mechanisms,
remove door, and reattempt installation.
22