Midea MGS30S2AST Instrucciones De Instalación página 9

• The installer is to instruct the resident/owner where the gas shut-off
valve is located.
• NEVER cover any slots, holes or passages in the oven bottom or cover
an entire rack with materials such as aluminum foil. Doing so blocks
airflow through the oven and may cause carbon monoxide poisoning.
• This appliance is shipped from the factory set for use with Natural Gas.
It can be converted for use with LP (propane). The conversion must
be performed by a qualified technician in accordance with the
installation instructions and local codes. The agency performing this
work assumes responsibility for the conversion.
• The appliance and its individual shut-off valve must be disconnected
from the gas supply piping system during any pressure testing of that
system at test pressures in excess of 1/2 psi (3.5 kPa).
• The appliance must be isolated from the gas supply piping system by
closing its individual manual shut-off valve during any pressure testing
of the gas supply piping system at test pressures equal to or less than
1/2 psi (3.5 kPa).
• Leak testing of the appliance shall be conducted according to the
manufacturer's instructions.
• This appliance is configurable to allow remote operation at any time.
Do not store any flammable materials or temperature sensitive items
inside oven, in storage drawer, or on top or near cooktop of the
appliance, including paper, plastic, pot holders, linens, wall coverings,
curtains, drapes, or cleaning chemicals.
• Do not allow anyone to climb, stand, lean, sit, or hang on any part of
an appliance, especially a door or drawer.
• This appliance has not been evaluated for use with any 3rd party
after-market systems. Do not attempt to use this appliance with a
wok ring or any other after-market device that may block air to the
burner or otherwise cause a fire or carbon monoxide hazard.
9