Electrical Supply Connection; Placement And Leveling - Midea MGS30S2AST Instrucciones De Instalación

• Position range to permit connection at the shut-off valve.
• Connect flexible metal appliance connector
to the shut-off valve.
• When all connections have been made leave
the range pulled out from installation space.
Make sure the shut-off valve is open and all
range controls are in the off position.
• Turn on the main gas supply valve and use
a liquid leak detector (or soap and water)
at all joints and conduits to check for leaks
in the system.
• Form the gas flexible connector as shown.
This will prevent the flexible connector from pinching or blocking the
unit when the unit is pushed into its final position.

Electrical Supply Connection:

• Installation must be electrically grounded in accordance with local
codes or, in the absence of local codes, with the National Electrical
Code, NFPA 70 or the Canadian Electric Code, CSA C22.1-02.
Connect electrical supply by plugging the
supplied power cord into a standard 3-prong
grounding wall receptacle. See Electrical
Supply Requirements in this manual for
detailed information and warning.
Where a standard two-prong wall receptacle
is encountered, contact a qualified electrician
to have it replaced with a properly grounded three-prong wall receptacle.
Do not use an adapter plug.
DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR REMOVE THE THIRD
(GROUND) PRONG FROM THE POWER CORD.

Placement and Leveling:

• When installing, moving, or servicing any appliance, wear proper
protective equipment, including cut resistant gloves, steel-toed shoes,
and safety glasses.
Do not move unit by pushing or pulling on the door or control panel.
•
• Do not lift by the cooktop edges. Push, pull, or lift only on the body
or structural areas, such as oven, oven face, or back corners of range.
Move range by lifting, not sliding, to prevent damage to floors.
• Use cardboard, plywood, or stiff plastic to protect floors if sliding is
necessary.
Gas Range Plug
29