Rear Filler Trim Installation - Midea MGS30S2AST Instrucciones De Instalación

• Attach anti-tip bracket to floor or wall.
o Wood Construction Installation: Drill a 1/8"
pilot hole where screws are to be located.
If bracket is to be mounted to the wall, drill
pilot hole at an approximate 20° downward
angle. Screw must enter wood.
o Masonry Construction Installation: Due to the
variety of masonry materials that may be
present at installation site, hardware is not
provided for attaching the anti-tip bracket to
masonry. If bracket is to be mounted to
masonry or ceramic floors, attach anti-tip
bracket using two 5/16" OD sleeve anchors
(with 1/4" bolt - either hex bolt head or hex
nut head) rated for minimum 300lb tension
for the masonry material present at
installation site.
Rear Filler Trim Installation (optional):
If there is no counter surface around the back edge of the installation
space, or if the countertop cutout is greater than 25" deep, this may
prevent the range from being installed flush to the back wall. If this
occurs, a trim kit can be installed to cover a gap up to 1 inch in width.
Contact Midea Customer Service to order a trim kit.
Counter continues around behind
installation space - no rear filler
trim required.
Directions:
• Align filler trim mounting holes.
• Attach with the screws provided with the trim kit.
FANSTEN BRACKET
(FLOOR MOUNTING ONLY)
Leveling leg
Floor Mount
No countertop behind at back of
installation space - rear filler trim
recommended.
More than
1-1/4"
Wall
Anti-Tip
Bracket
27