Midea MGS30S2AST Instrucciones De Instalación página 30

Getting the unit properly placed in the installation
space and level may require multiple attempts.
It is recommended to measure and adjust leveling legs
carefully before placing into the installation space, as
the leveling legs may be difficult to adjust once the
range is in its final position.
All ranges are heavy - sliding the range can damage the floor. Use care
when moving the range. Use a belt when moving the range to prevent
damaging the floor, or use cardboard, plywood, or stiff plastic to avoid
damaging the floor while sliding the range.
CAUTION: Please DO NOT
push the unit strongly when
you install. These actions can
cause the damage to the unit.
Directions:
• Use tape measure to measure from the floor to the top of the counter
top at all four corners of the installation space.
• While range is still positioned outside the installation space, adjust the
leveling leg at each corner so that the distance from the floor to the
underside of the cooktop edge matches the dimensions measured in
the installation space.
• Using two people, move range into its final installation location, being
careful not to damage countertops, floor, or appliance.
o IMPORTANT: Do not move unit by pushing or pulling on the door or
control panel. Do not lift by the cooktop edges. Push, pull, or lift only
on the body or structural areas, such as oven, oven face, or back
corners of range.
o Be careful not to pinch or kink the gas or electrical connections.
If unit does not move in smoothly, check for obstructions. Do not
attempt to force the unit into position.
o Dampening the countertop where the cooktop overhangs with
soapy water may allow the range to slide into position more smoothly.
o The metal flange under each side of the cooktop MUST be placed
over the cabinet countertop for proper unit support. The cooktop
should NOT rest directly on the countertop or else it could cause
damage to the cooktop voiding the warranty.
30
Please DO NOT grasp the
knob and push when you
install. (Grasp the L/R door
area to push the unit)