Main Menu - Grundfos Conex DIA-2 Instrucciones De Instalación Y Funcionamiento

Ocultar thumbs Ver también para Conex DIA-2:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 104

11.4 Main menu

1. Switch to "main menu" by pressing [OK] or, if
necessary, by pressing [Esc] several times.
Options in "main menu"
main menu
controller
alarm
service
setup
"controller"
In this submenu, a controller can be parameterised.
This option will only be displayed if a type of
controller has been selected in the "setup" menu.
"alarm"
In this submenu, the measured value is compared
with the permitted value, and an alarm is triggered,
if necessary.
"service"
Diagnosis submenu. The measured values and
the last 10 alterations of calibration data can be
viewed. In this mode, values cannot be altered.
If measuring cell AQC-D2/-D12 is selected, the
data of the water sensor can be viewed.
"setup"
In this submenu, the settings for language,
parameters, measuring ranges, controllers, etc.
can be adjusted.
Selecting the functions "calibration" and
"manual operation"
See the buttons [Cal] and [Man] to the right of the
display.
Calibration: Press [Cal] to switch to the
calibration menu (the yellow LED illuminates).
Manual operation: Press [Man] to switch to
manual operation (the yellow LED illuminates).
Switching to manual operation is only
possible if a controller type has been
selected in the "setup" menu. The
Note
functions "Cal" and "Man" can only be
accessed by persons with calibration rights
or full rights.
30

Publicidad

Tabla de contenido
loading

Tabla de contenido