Main Menu Setup - Grundfos Conex DIA-G Instrucciones De Instalación Y Funcionamiento

11.7 Main menu
• From display mode, press [OK] or from the
submenus, press [Esc] the relevant number of
times to access the main menu.
Selection options in the main menu
• "Sensor 1 / Sensor 2": parameterisation of
sensors. Menu selection "Sensor 1" or "Sensor 2"
for parameterisation is displayed in the "Setup"
menu, depending on the preselection.
• "Service" diagnostic menu (list of events): display
of measured values, current output, relay and
display test. Values cannot be changed in this
mode.
• "Setup" menu: settings for language, sensors,
relays, battery backup, current output, etc.
• "Fine adjustment" menu: sensor calibration and
display damping.
In the following, unlike the menu
sequence, the device setup is described
Note
first because it is completed first when
setting the device for the first time.
11.8 Setup
Main menu > Setup
Submenu 1
Language
Sensor 1
Sensor 2
Limit relay
Alarm relay
Battery backup
Date/time
Code function
Display
Factory setting
CAN interface
Current output
Program version
All standard settings of the device can be configured
in the "Setup" menu. During initial commissioning,
basic functions are configured which after that
should only be altered rarely or even not at all.
Once the code has been set, access to the
Note "Setup" menu requires level 2 rights. See
section 11.8.8 Code
11.8.1 Selecting the operating language
In the "Language" submenu, the language is
selected for all subsequent entries and displayed
text.
The word "Language" appears in the header in each
of the available languages, changing about once
every second. The list of available languages
(English, German, French, Spanish, Russian, Polish)
is displayed.
Select the desired language.
Sprache..Language..
Deutsch
English
Español
Français
Changing the language does not affect any
Note
set values.
function.
35