Important - Stiga ST 266 HW Manual De Instrucciones

• Assembling and adjusting the leveling shoes
(fig. 3)
1. Place the snow thrower on a level surface
2. Use the supplied screws and nuts (fig. 3.A)
3. Only For ST 276 HT model: Move the auger group
lifting lever (fig. 6.B) to the unlock position
4. Push down on the handlebars to raise the auger off
the ground
5. Place the shoes (fig. 3.B).
6. Adjust the shoes up or down to obtain the desired
height of the auger from the ground
7. Fasten the screws and nuts.
•
• Assembly of the auger unit lifting lever (only for
model ST 276 HT) (Fig. 4)
4. CONTROLS
• Start/safety key (Fig. 5.A)
he engine will not start if the safety key
T

IMPORTANT

is not completely inserted.
In case of emergency, remove the key.
• Fuel tap (fig. 5.B)
• Throttle command (Fig. 5.C)
Regulates the engine's r.p.m.
1. Full capacity.
2. Minimum.
3. Stop position (if available).
4. Intermediary position (if available)
• Choke command (Fig. 5.D)
It is used to cold start the engine.
The choke is engaged (for cold start
The choke is disengaged (normal operation
and warm start)
• Primer (Fig. 5.E)
Facilitates the engine cold start
• Manual starting grip (Fig. 5.F)
Allows the engine to be started by hand.
• Electrical start command (Fig. 5.G)
Allows the engine to be started electrically.
• Forward control (OPC) (fig. 6.D)
Allows
forward.
.
.
).
.
.
moving the machine
• Gear lever (fig. 6.A)
The machine is equipped with a gearbox
operated by a progressive function lever,
to go forward and to go backward
• Auger control (fig. 6.C)
• Steering lever
Allows easier
NOTE Turning without using the lever may be more
difficult.
NOTE Turning without using the lever may cause the
.
track to be displaced. (ST 276 HT)
• Chute orientation (fig. 6.L) and Deflector (fig.
6.M) switches
• Headlight switch (fig. 6.F.)
• Grip heating switch (fig. 6.G.)
NOTE Do not use at temperatures > 20 °
• Auger group lifting lever (Fig. 6.B.)
Adjustes the operating height of the auger
EN - 4
if not in use, return the lever to neutral.
Operates the auger rotation.
steering of
To turn to the right, press the lever
(fig. 6.H)
To turn to the left, press the lever
(fig. 6.I)
Allows guiding the snow discharge
in the desired direction
the machine: