Stihl FS 90 Manual De Instrucciones página 29

STIHL TrimCut 31-2,
STIHL FixCut 25-2,
STIHL PolyCut 20-3
1
Turn the mowing head
N
counterclockwise until it is flush
against the shaft (1)
Block the shaft
N
Tighten the mowing head
N
Remove the tool used to block the
shaft.
Removing the mowing head
Block the shaft
N
STIHL SuperCut 20-2,
STIHL AutoCut 25-2,
STIHL AutoCut C 25-2,
FS 90, FS 90 R
STIHL TrimCut 31-2,
STIHL FixCut 25-2,
STIHL PolyCut 20-3
Turn the mowing head clockwise
N
Feed out mowing line
STIHL SuperCut
Line is fed out automatically if the
mowing line is at least 2 1/2 in. (6 cm)
long – the blade on the deflector
shortens excessively long mowing line
to optimum length.
STIHL AutoCut
Hold the mowing head parallel
N
above the surface of the lawn – tap
it on the ground – approx. 1 1/4 in.
(3 cm) of mowing line is fed out
The blade on the deflector shortens
excessively long mowing line to
optimum length – thus repeated tapping
in succession is to be avoided!
Mowing line is only fed out if both
mowing lines are still at least 1 in.
(2.5 cm) long!
For all other mowing lines
Proceed as described in the mowing
head information sheet.
Always switch off the engine to
fed out mowing line by hand –
otherwise there is a risk of injury!
Replacing mowing line and/or cutting
blade
Proceed as described in the mowing
head information sheet.
Mounting metal cutting attachments
The skirt and lne limiting blade are not
required on the deflector for grass
cutting blades 230-4 (1), 230-8 (2) or the
brush knife (3) – see "Mounting the
Deflector".
Fit the approriate limit stop for
circular saw blades 200 (4, 5) –
see "Mounting the deflector".
Lay your brushcutter on its back with the
cutting attachment mounting face
pointing up: The cutting edges of (1) and
(3) may point in either direction. The
cutting edges of (2), (4) and (5) must
point clockwise.
Direction of rotation is indicated by an
arrow on the inside of the mowing
attachment deflector or limit stop.
English
27