Spark Arresting Screen In Muffler - Stihl FS 90 Manual De Instrucciones

English
Engine stops while idling
Turn the idle speed screw (LA)
N
slowly clockwise until the engine
runs smoothly – the cutting
attachment must not move.
Cutting attachment runs when engine
is idling
Turn the idle speed screw (LA)
N
counterclockwise until the cutting
attachment stops running and then
turn the screw about another 1/2 to
3/4 turn in the same direction.
If the working tool or cutting
attachment continues to run when
the engine is idling, have your
machine checked and repaired by
your servicing dealer.
Erratic idling behavior, engine stops
even though setting of LA-screw has
been corrected, poor acceleration
Idle setting is too lean:
Turn the low speed screw (L)
N
counterclockwise, no further than
stop, until the engine runs and
accelerates smoothly.
Erratic idling behavior
Idle setting is too rich
Turn the low speed screw (L)
N
clockwise, no further than stop, until
the engine runs and accelerates
smoothly.
38
Spark Arresting Screen in
Muffler
In some countries the muffler is
equipped with a spark arresting screen.
If the engine is down on power,
N
check the spark arresting screen in
the muffler.
Wait for the muffler to cool down.
N
Move the slide control to STOP-0.
N
Take out the screw (1).
N
3
2
Take out the screws (2) and remove
N
the shroud (3).
Take out the screw (4).
N
Lift the spark arresting screen (5)
N
and pull it out.
Clean the spark arresting screen. If
N
the screen is damaged or heavily
1
carbonized, fit a new one.
Refit the spark arresting screen.
N
Insert the screw and tighten it down
N
firmly.
Fit the shroud.
N
2
FS 90, FS 90 R