Balancing The Trimmer/Brushcutter - Stihl FS 90 Manual De Instrucciones

English
Full harness
Put on the full harness (1).
N
Adjust the length of the strap so that
N
the spring hook (2) is about a hand's
width below your right hip.
Balance the trimmer/brushcutter.
N
32
Balancing the
Trimmer/Brushcutter
Connect machine to harness
The type and version of the harness and
snap hook depend on the market.
Hook the snap hook (1) into the
N
carrying ring (2) on the shaft
Undo the screw (3)
N
Balance the machine
The machine will balance differently
depending on the cutting attachment
mounted.
Until the conditions listed under
"Hanging positions" are met, carry out
the following steps:
Move carrying ring
N
Tighten screw lightly
N
Let the machine swing until it stops
N
moving
Check hanging position
N
FS 90, FS 90 R