Stihl FS 90 Manual De Instrucciones página 36

English
Control handle on drive tube
7
3
2
1
1 Throttle trigger lockout
2 Throttle trigger
3 Slide control
Positions of slide control
4 STOP-0 – engine off – the ignition is
switched off
5 F – normal run position – the engine
is running or can start
6 START – the ignition is switched on
– the engine can start
Symbol on slide control
7 h – stop symbol and arrow. To stop
the engine, push the slide control in
the direction of the arrow on the stop
symbol (h) to STOP-0.
34
Starting
Press down the trigger lockout lever
N
and squeeze the throttle trigger.
4
and hold them in that position.
N
Move the slide control to START
N
5 and hold it there.
Now release the throttle trigger,
N
6
slide control and trigger lockout in
that order. This is the starting
throttle position.
Set the choke knob (8):
N
g if the engine is cold
e for warm start – also use this posi-
tion if the engine has been running
but is still cold.
Press the fuel pump bulb (9) at least
N
five times – even if the bulb is filled
with fuel.
9
8
Starting
Place the unit on the ground: It must
N
rest securely on the engine support
and the deflector. Check that the
cutting attachment is not touching
the ground or any other obstacles.
Make sure you have a safe and
N
secure footing.
Hold the unit with your left hand and
N
press it down firmly – your thumb
should be under the fan housing.
Do not stand or kneel on the drive
tube.
FS 90, FS 90 R