Publicidad
Idiomas disponibles
Idiomas disponibles
Threading 4/3 Thread OL
1
3
5
6
7
4
8
6
9
Thread
guide No. 1
2
10
7
11
Left-hand needle, beige markings
Switch the machine off (power switch"0")
Place the spool on the spool holder pin as illustrated.
(1) Thread the thread guide which is located just above
the spool from back to front.
At this time, fit the thread firmly in the groove.
(2) Thread the thread guide No.1
(3) Route the thread in the groove.
(4) Put the thread under the thread guide plate.
(5) Thread the thread take-up cover (marked in beige)
(6) Thread the thread guide.
(7) Thread the needle bar thread guide (left-hand side).
(8) Turn the handwheel toward you to align the " " mark
with the " " mark on the side face of the side cover.
Then, lower the presser foot.
(9) Set the right-/left-needle changeover lever to the left
needle side.
Be sure to move the right-/left-needle changeover
lever to the left needle side until it will go no further.
(10) Lower the threading lever as far as it goes.
(11) Push the thread into section A with both hands.
(12) The thread automatically passes through the needle
eyelet by pushing the threading lever upward.
(13) Lift the presser foot.
(14) Pull out the thread by approximately 10 cm to route it
under the presser foot and draw it out from its rear.
A
13
12
14
30
Publicidad
