Publicidad
Idiomas disponibles
Idiomas disponibles
Trial sewing
Sewing test
Sew two pieces of the material together. Then, check whether or not the
finished seam is correct.
1. Close the looper cover. Turn the power on.
2. Check that the upper knife is raised.
3. Lower the presser foot.
4. While holding the thread trailing from the rear of the presser foot by
hand, depress the controller to produce chain-off thread by 6 to 7 cm.
5. Raising the front part of the presser foot with fingers, put the fabric
under the presser foot until this side of the upper knife is reached.
6. Start the sewing machine.
7. After the completion of sewing, cut the chain-off thread.
How to cut the chain-off thread
❶ Press the chain-off thread cutting button
After the completion of sewing, press
thread.
❷ Enable the automatic chain-off thread cutting function in prior
Press
.
Refer to page 22 for details.
❸ Cut the chain-off thread with the thread cutter
1. After the completion of sewing, produce chain-off thread by 5 to 6 cm.
2. Put the chain-off thread over the thread trimming blade for trimming.
❹ Cut the chain-off thread with the upper knife
Pull the chain-off thread and bring it toward you. Then, cut it with the
upper knife.
❺ Depress the foot switch
After you have completed sewing, depress the foot switch to cut the
chain-off thread.
* In order to cut the chain-off thread by depressing the foot switch, it is
necessary to set the function of the foot switch accordingly in advance.
(Refer to page 9)
to cut the chain-off
32
Publicidad
