Cover And Pool Cleaning - Metcalfe TR 70 Manual De Instrucciones Para Uso Y Manutención

The moving parts have to be disassembled
as follows:
• Mixer: make sure the external shovel is in
the upper vertical position (Fig. 13
(only this position allows the disassem-
bling of the piece).
For model TR 70: remove the mixer, pull
out the knob (Fig. 13
disengages;
for model TR 75/E: remove the mixer by
unscrewing the external mobile support
until the mixer disengages (Fig. 13 bis
Take the square shaft away from its place
(Fig. 13 ) and at the same time turn the
C
external end upwards. If you want to
assemble the piece follow these instruc-
tions vice versa. Line the central point of
the shaft with the peg of the moving sup-
port; then, leave the handle.
• Ring nut: (Fig. 13
(Fig. 13 ): unscrew the ring nut by hand,
E
avoiding pieces falling when the ring nut
comes out of its place, in order to avoid
causing damage both to people or to the
pieces themselves.
• Archimedean screw: (Fig. 13
disassembling the ring nut and the draw-
plate, the Archimedean screw can easily
be taken off from the machine by pushing
its spiral from the internal end.

6.1 COVER AND POOL CLEANING

Eliminate the dough residue and make sure
to thoroughly clean the most remote-access
pieces: connections of the Archimedean
screw and mixer movements (Fig 14), extru-
sion sleeve, cover and pool internal parts.
Use some warm water in order to eliminate
the residual product and then rinse; dry the
surfaces with the help of blotting paper.
WARNING: Never use non-nutritional,
abrasive or corrosive chemicals to
clean. Also never use coarse or abrasi-
ve objects such as steel wool, abrasive
sponges and so on.
To clean machine internal and external
parts:
A
) until the mixer
B
).
A
) and drawplate
D
): after
F
)
C
Fig. 13
A
Fig. 13 bis
Fig. 14
Fig. 15
26
F
D
A
A
B
E