Boston Scientific Vercise DBS Manual Del Usuario página 18

Vercise DBS Charging Handbook
TM
Using the Adhesive Patch
1. When the indicator light is green, remove the
Charger from the Base Station.
Note: Once the Charger is removed from the
Base Station, the Charger indicator light
will turn off regardless of the ready status
of the Charger.
2. Apply the Adhesive Patch to the backside of the
Charger by peeling the clear liner from the patch
and applying the white side with the blue stripe to
the rear of the Charger (Figure 5).
3. Remove the skin side beige liner from the adhesive (only good for one fixation).
4. For best charging results, make sure the Charger is centered over the Stimulator. If the Charger is not centered,
charging time may increase. See the "Properly Aligning the Charger" and "Tips for Properly Aligning the Charger"
sections of this manual to ensure you center the Charger over the Stimulator. It is recommended that you follow the
instructions in both sections the first time you charge your Stimulator.
Note: Do not put the Charger directly on the skin (e.g., without an Adhesive Patch).
Vercise DBS Charging Handbook
TM
92357527-07 Page 14 of 101
Figure 5.
Peel the Clear Liner from the Adhesive Patch